How do you replace the ball joints on a Mustang?

Answer by  laura27 (1216)

Jack car up, take wheel off where ball joint is, remove it with Medal C-Clamp, put rachet on top. Cheetah bar on for leverage, unscrew till fall off. reverse procedures.

Answer by  jay34 (250)

First take the wheel off where the ball joint is . When you get to ball joint remove it with a Medal C-Clamp then put a rachet on top. Then cheetah bar on it for leverage. Unscrew till it falls off. Reverse this procedure to put joint on.

Answer by  kennethjgoodson (4903)

You are going to need to get the front end of the car in the air and pull the tires off. You can pull the brakesand rotor off andyou will see the control arm and the ball joints. You anr going to want to get a puller because they are pressed on.

Answer by  palmerino (637)

Jack up the front end, and take off the wheels. Then unbolt the ball joint from the steering knuckle, then unscrew the entire joint (mark its location with something) and replace in reverse. Do the same on the other side if you need to. Then take it to get the steering alignment done.

Answer by  laura27 (1216)

Take wheel off to get to the ball joint. Get a medal c clamp and put a ratchet on top. unscrew the whole joint off until it fall off.

Answer by  japratt (1687)

In order to replace the ball joints of the Mustand you will need a lift since the car is low to the ground.

Answer by  samisaysalways70 (69)

According to me if you want to replace the ball joints on a mustang, you have to concern a good mechanic for that.