How do I wire a well pump?

Answer by  lgcrow (26)

Depending on the size and amp rating of the pump you connect the leads usually red black and yellow if it is a three phase, no yellow if single phase to the pressure switch in order from left to right looking from the rear of the switch black, red, yellow you then connect the incomming leads on the opposite side

Answer by  geethapriya (239)

First of all check the rating of the well pump and also how many phase used for the well pump. Then check your EB connection needed phase are available or not. if available then first given the connection the switch gear box then give connection to the well pump from the switch gear box. proper earth is must.

Answer by  Jdog37 (592)

You will want to run a dedicated circuit for your pump. Most pumps are simply 120. So all you will need to do is run a 14-2 wire to it.